Oct 16, 2013

Posted by in Uncategorized | Comments Off on Answers About Asphalt Seal Coating in Worcester, MA

Answers About Asphalt Seal Coating in Worcester, MA

New England Sealcoating is a company that provides Asphalt Seal Coating in Worcester, MA. Sometime down the line, your new asphalt driveway will have to be touched up due to wear and tear of heavy vehicles driving over it, from sun damage, and from winter ice and snow. The weight of the vehicles may cause cracks to form, as can the expansion and contraction from the alternating heat in the summer and cold in the winter. Cars that leak oil or other fluids onto the driveway can also cause small cracks or erosion over time.

It isn’t wise to wait until you see cracks in the driveway to call for repairs. Instead, during the first year after you get a new asphalt driveway, you should arrange for maintenance for your Asphalt Seal Coating in Worcester, MA. That way, it can be maintained so those cracks don’t appear in the first place. In fact, if you use a maintenance program, your pavement can last twice long as it would otherwise. Asphalt should be sealed again every two to three years.

The same Asphalt Seal Coating in Worcester, MA that is applied to driveways can also be applied to parking lots. Parking lots are subject to even more abuse because they have more traffic and heavier vehicles. However, it does not work well on concrete or cement, just on asphalt.

Some asphalt sealers don’t last long, and that may be due to the contractor not cleaning the surface properly before applying the sealer. Also, the contractor may have diluted the sealer too much, or the parking lot owner allowed vehicles to drive on the surface too soon after treatment. Of course, sometimes the surface is just too worn or oxidized to be able to let the sealant adhere well, even if a primer was put down before the sealer. A primer should always be used, though, for the best chance at adhesion.

If a parking lot owner has a parking lot sealed, they should wait 24 hours before allowing traffic on it. However, if the contractor uses the right kind of sealer additive, that time may be cut down to 12 hours.

4header-highfriction1

Share

    Pin It on Pinterest

    Shares
    Share This